Anchor Kit #1 Refinishing

The Solution to Rusty Anchors

Make your rusty anchor look new again.
Faster and less expensive than re-galvanizing.  Do it yourself !

Our #1 refinishing anchor kit is made from a high grade, two part, 100% epoxy with anti-corrosion resistance filters, to be used for any environment. This exclusive #1 anchor kit can be applied over manually or mechanically prepared surfaces to provide a primer or top coat for rusty surfaces. It can be easily applied by brush or roller to achieve a 6 to 12 mils dry film thickness.

Our refinishing anchor kit is a non flammable, high adhesion and anti-corrosion resistant material. You can partially mix the system or mix the entire unit. This #1 anchor kit product cures down to 35F in high humidity environments.

Preparation

Remove all oil, grease and wire brush, grind or use a sand blast.

Mixing and Application

Mixing Ratio: 3 to 1 by volume
Color: Silver Grey
Non Flammable
Clean up tool: MEK or Toluene
Percent Solids: 100%

Caution

Can cause skin and eye irritation. Avoid contact with skin, eyes, and clothing. Consult MSDS for more information.

Important

Follow all instructions. Mix 3 to 1 by volume. Apply three coats to all surfaces of the anchor. Let cure for three days before use.
You can partially mix the contents of the kit.

Working & Curing: 68F (20C)
Useable life – 35mins. at 68F
Touch Dry – 8 hours at 68F
Hard Dry – 16 hours at 68F
Minimum over coating:
6 hours at 68F
Maximum over coating:
12 hours at 68F
Cooler temps = longer time
Warmer temps – shorter time

Cures down to 35F in high humidity environments.

NON-FLAMMABLE

EXCELLENT  CORROSION RESISTANCE

HIGH ADHESION

LONG TERM PROTECTION

Quart kits cover 53 sq. ft at 6 mils dry film thickness

Refinishing Anchor Kit: $89.99

(Plus shipping and tax
where applicable)

Anchor Kits can be ordered from:

Sea Tech & Fun USA
This e-mail address is being protected from spambots. You need JavaScript enabled to view it
www.spadeanchorusa.com
(321) 409 – 5714

MADE IN THE USA

 Anchor Kit Refinishing #1 Tips from A Satisfied Customer

Anchors are expensive and maintaining them is a challenge for all cruisers, regardless of cruising ground. If you put your anchor in the water…. and sometimes if you don't, sooner or later it's going to end up rusty. More...