Anchor Refinishing Kit

Anchor Refinishing Kit

Make your rusty anchor look new again. 

Our Anchor Refinishing Kit works faster than re-galvanizing, and it is also less expensive to do it yourself!

Our Anchor Refinishing Kit can be used as an important part of your anchor maintenance routine. This anchor care kit is made from a high grade, two-part epoxy with corrosion-resistant filters for use in any environment. Our exclusive anchor maintenance kit can be applied over manually or mechanically prepared surfaces to provide a primer or top coat for rusty surfaces. The Anchor Refinishing Kit can be easily applied by brush or roller to achieve a dry film thickness of 6 to 12 mils.

This anchor care kit is made from non-flammable materials that are also highly adhesive and anti-corrosive. You can partially mix the system or mix the entire unit depending on the project. The Anchor Refinishing Kit cures down to 35 degrees Fahrenheit in high humidity environments.

Preparation

Remove all oil and grease. Wire brush, grind or use a sand blast.

Mixing and Application

Mixing Ratio: 3 to 1 by volume
Color: Silver Grey
Non Flammable
Clean up tool: MEK or Toluene
Percent Solids: 100%

Caution

Can cause skin and eye irritation. Avoid contact with skin, eyes, and clothing. Consult MSDS for more information.

Important

Follow all instructions. Mix 3 to 1 by volume. Apply three coats to all surfaces of the anchor. Let cure for three days before use. You can partially mix the contents of the kit.

Working & Curing: 68F (20C)
Useable life – 35mins. at 68F
Touch Dry – 8 hours at 68F
Hard Dry – 16 hours at 68F
Minimum over coating:
6 hours at 68F
Maximum over coating:
12 hours at 68F
Cooler temps = longer time
Warmer temps – shorter time

Cures down to 35F in high humidity environments.

NON-FLAMMABLE

Made In the USA!

EXCELLENT  CORROSION RESISTANCE

HIGH ADHESION

LONG TERM PROTECTION

paintkit3

Anchor Refinishing Kit $89.99

BUY NOW

paintkit4Anchor Kit Refinishing Tips from A Satisfied Customer

Anchors are expensive and maintaining them is a challenge for all cruisers, regardless of cruising ground. If you put your anchor in the water…. and sometimes if you don’t, sooner or later it’s going to end up rusty. More…

All information given is based on practical refinishing anchor kit experience and given in good faith. No warranty is expressed or implied as the use of this material is beyond the control of the company. Manufacturer nor seller shall be liable for any injury, loss or damage either directly or indirectly related to the use of this product. It is the sole responsibility of user to assure proper use and suitability of this refinishing anchor kit product for it’s intended use.